20' plus mills
-
windmillerman
- Posts: 142
- Joined: Sat Dec 15, 2018 9:40 am
20' plus mills
a few
You do not have the required permissions to view the files attached to this post.
-
windmillerman
- Posts: 142
- Joined: Sat Dec 15, 2018 9:40 am
Re: 20' plus mills
more
You do not have the required permissions to view the files attached to this post.
-
windmillerman
- Posts: 142
- Joined: Sat Dec 15, 2018 9:40 am
Re: 20' plus mills
3 more
You do not have the required permissions to view the files attached to this post.
Re: 20' plus mills
Thanks for photos
I'm a fan of the big mills, so this is cool!-
Ron Stauffer
- Posts: 540
- Joined: Fri Dec 14, 2018 10:25 am
- Location: Uncompahgre Plateau Montrose CO
- Contact:
Re: 20' plus mills
24' Kijito on 40' tower
Ron Stauffer
Montrose CO
Ron Stauffer
Montrose CO
You do not have the required permissions to view the files attached to this post.
Re: 20' plus mills
Where is the Double Header. i know there is one on a barn in Ca but didn't know of that one. Yes they are magnificent. Every time I see one of these big mills in the air I wonder about the crew that put them up in the 1890's. What an operation it must have been.
Re: 20' plus mills
Ding, ding, ding, I know where the Stover picture was taken
-
windmillerman
- Posts: 142
- Joined: Sat Dec 15, 2018 9:40 am
Re: 20' plus mills
Double header is CA's, where was the Stover? where was this one with Collum's on it? Obrock knows where the foreigner's are from...Australia?
You do not have the required permissions to view the files attached to this post.
Last edited by windmillerman on Tue Jan 22, 2019 4:05 pm, edited 1 time in total.
Re: 20' plus mills
There was a Collums Hardware in San Antonio. Jim had a vane on his wall at Poteet.
