is this a windmill part ?

mtblah · Post by **mtblah** » Sat Dec 03, 2022 5:50 pm

measurements are square , hole in the center is square , no casting #'s , no name .
Is it a windmill part , or just something that was in the box of "stuff " ?
Mike B
New Braunfels TX

Windcatcher530 Dan · Post by **Windcatcher530 Dan** » Sat Dec 03, 2022 6:11 pm

Looks to me it's a tower cap or part of one.

CTXmiller · Post by **CTXmiller** » Sat Dec 03, 2022 6:39 pm

Looks Stover, like my AirFlow tower cap.
Photo added

mtblah · Post by **mtblah** » Sat Dec 03, 2022 7:35 pm

I agree , thank you for knowing that .

mtblah · Post by **mtblah** » Sat Dec 03, 2022 8:04 pm

the tower leg "holder" bolted up to the plate under the Ideal Steel

mtblah · Post by **mtblah** » Sat Dec 03, 2022 8:10 pm

attached square holder

CTXmiller · Post by **CTXmiller** » Sat Dec 03, 2022 8:19 pm

I think I posted this on here at some point in the past, but it seems Stover made this adapter plate and likely other adapter plates for what you’re doing with that Stover tower top.

Windcatcher530 Dan · Post by **Windcatcher530 Dan** » Sat Dec 03, 2022 8:24 pm

I believe that top plate is like the one on my Samson open gear.

Vintage Windmill and Wind Generator Forum

is this a windmill part ?

is this a windmill part ?

Re: is this a windmill part ?

Re: is this a windmill part ?

Re: is this a windmill part ?

Re: is this a windmill part ?

Re: is this a windmill part ?

Re: is this a windmill part ?

Re: is this a windmill part ?