Vintage Windmill and Wind Generator Forum

Is there outside corners for 75 degree angle like used on 3 legged towers. I need 3. Thanks Wayne

For what? Not sure what you mean.

I have for 4 leg tower cast pieces for both inside the corner and outside the corner your bolt goes through when the hole is in the bend and not on the side. Gives your bolt a flat area to rest on. I don't know if I've ever seen any for 3 leg but would think they would have made them. I think maybe Dempster made them and maybe Woodmanse for 4 leg.

Wayne,
Are these what you're referring to? These came off my Stover 3 legged tower (I'm missing one in case anyone has some extras.)
The squares on the mat are one inch squares to give an indication of size. The grove is rounded (rather than a V groove) to match the curved bend in the leg angles.

Regards,
Jim

The outside corners on a 3 legged Dempster storm stay look close to 90, if that is what you’re inquiring about. The angle iron is less than 90 like you mentioned.

Yes Jim that is what I'm talking about. Seems we may both be searching for the same thing. The 75 degree angle is rounded on the corners. So they did make them now if anybody has any they want to part with.