Vintage Windmill and Wind Generator Forum

Does anybody remember who made these scaled down Aermotors? Maybe 10 to 15 years ago. The wheel is approximately 2 foot diameter.
Gregg

Gregg wrote: Fri Apr 25, 2025 6:21 pm Does anybody remember who made these scaled down Aermotors? Maybe 10 to 15 years ago. The wheel is approximately 2 foot diameter.
Gregg
Miniature Aermotor.jpg

Could it be this gentleman? $600 is what they relay to cost.

I think your right. Thanks.
Gregg

That is pretty neat but I would have done a 502

Ken O-Brock sold a miniature working Aermotor a few years ago. Don't know who made it.

Ken sold the 4' Iron Man windmill that was made in China. There was recently sold on Bill Cherry's estate auction that he got from Ken.
Gregg

there is a guy who still makes those, located in neb. he built a helmet for me, mine was missing, buddenberg no longer doing those, if I can find his contact ill put it here, pm me in a week to remind me, I told him he should do the TF, he stated he didn't want to b that busy, lol

jay builds those still, 308 529 2494, doesn't deliver over a 100 miles,

I was at Barb Feilmeiers last week, Roger had gotten one from somebody in Nebraska. She couldn't remember who he got it from but he was very proud of it. Told her I would try to find out. Thanks for the info.
Gregg