Any recommendations on repairing this snout nose on A702 Aermotor? Thanks.
Jerry
Aermotor A702 Snout Rib Broken Off
Aermotor A702 Snout Rib Broken Off
You do not have the required permissions to view the files attached to this post.
Jerry Wade Barker
Wills Point, Texas
214-893-2864
www.farmhousewindmills.com
farmhousewindmills@hotmail.com
Wills Point, Texas
214-893-2864
www.farmhousewindmills.com
farmhousewindmills@hotmail.com
Re: Aermotor A702 Snout Rib Broken Off
Weld it, or leave it. I don't know what harm could be done by leaving it. Maybe Ron knows something.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: Aermotor A702 Snout Rib Broken Off
Could cause oil to leak out of the hub. Nickel weld and grind down to match the rest of the snout OR you could use your epoxy of choice (not a support piece) and form it to match the rest of the snout. This will keep the oil in the area where it can be scraped off the inside of the hub and placed back into the gear box.windybob wrote: Mon Mar 11, 2019 7:11 pm Weld it, or leave it. I don't know what harm could be done by leaving it. Maybe Ron knows something.
Bryon
-
Ron Stauffer
- Posts: 536
- Joined: Fri Dec 14, 2018 10:25 am
- Location: Uncompahgre Plateau Montrose CO
- Contact:
Re: Aermotor A702 Snout Rib Broken Off
Fixing the outside ring will be good practice for fixing the important one, the one between the oil collector and the case. It is worn badly on the top so is out or round. When fixing the outside one, make sure the face is flat.
Ron Stauffer
Montrose CO
Ron Stauffer
Montrose CO
