Page 1 of 1
winco 12 v wincharger manuel
Posted: Thu Feb 16, 2023 2:47 pm
by EarthQuaker
Hi, I have a 1978 or so Wincharger 200watt 12volt. The voltage regulator device bolted to tail section was smashed. Was wondering about using a 10A solar controller in place of the destroyed transistorized unit. Does the pos. go to controller first ? only 2 terminals on slip ring. Id like to have a picture of the intact device on a working Wincharger like mine.
Thanks, Ed
Re: winco 12 v wincharger manuel
Posted: Thu Feb 16, 2023 6:39 pm
by Wind Charger Mike
Scanned Document 6.pdf
The attached diagram might help you
Re: winco 12 v wincharger manuel
Posted: Wed Feb 22, 2023 5:06 pm
by EarthQuaker
Wind Charger Mike wrote: Thu Feb 16, 2023 6:39 pm
Scanned Document 6.pdfThe attached diagram might help you
Hi, thanks, I got message: didn't have the required documents to scan pdf"
Re: winco 12 v wincharger manuel
Posted: Wed Feb 22, 2023 5:07 pm
by EarthQuaker
Wind Charger Mike wrote: Thu Feb 16, 2023 6:39 pm
Scanned Document 6.pdfThe attached diagram might help you
Ooops ....required perrmission?
Re: winco 12 v wincharger manuel
Posted: Wed Feb 22, 2023 5:58 pm
by EarthQuaker
Wincharger :Model W02HS4D-212H/A
Ser 75175 U 83
Volts 12
watts 200
Mian question:What is the transistorized unit? Did it turn the circuit on / off based on wind speed? I built a wind machine in 1981 that had a small wind vane hooked to a momentary switch that turned the alternator on when it hit 7 mph. My question is if I can abandon the 12 gauge multi-strand wire hooked to broken transistorized/ capacitor device all together? I would use a solar controller 20amp or so...? Im assuming there is no replacement part for this wincharger unit.