Page 2 of 2
Re: Stover Tower Steps
Posted: Tue May 05, 2020 9:51 am
by mtblah
As I have written before, it is amazing the knowledge, patience, expertise, the you are willing to share with those of us less " fortunate " !
Mike B
New Braunfels TX
Samson / Stover tower w/ aermotor engine.
Re: Stover Tower Steps
Posted: Tue May 05, 2020 10:24 am
by Wayne
Amen to that brother! I think somebody needs to spend some time with Windy and put all the great stuff in a book.
Re: Stover Tower Steps
Posted: Tue May 05, 2020 2:20 pm
by Aermotor Fan
Bob,
That is a cool jig you made. You could make the monitor tower
steps with that like said before.
Adam
Re: Stover Tower Steps
Posted: Tue May 05, 2020 5:08 pm
by windybob
Thanks! It took 4 fixtures to get those steps shaped and drilled right. Not including cutting them on the shear.
Monitor steps are made from heavier material. will take some serious strength for those. I do have some 16 ga material. Hmmm
Re: Stover Tower Steps
Posted: Wed May 06, 2020 9:51 am
by JBarker
Go Bob Go!