Introduction

[CTXmiller]

This has examples of offset pumping:

https://www.obrockwindmills.com/obrockw ... mping.html

viewtopic.php?p=5564&hilit=Offset#p5564

[windybob]

my neighbor has an offset well. Good planning will also help to keep it from freezing in the winter.

[Copter404]

The Mill actually looks in good condition besides the broken main shaft. Like Michael said you want to lower the wheel down to avoid damage and same with the Mill. Good Luck !!

This may sound like a stupid question to a bunch of old pros, but which picture do you see the broken main shaft in and are you able to point it out? Also, is that an easy part to come by for this particular specimen?

[CTXmiller]

Because the hub separated from the gearbox and there is no main shaft visible (remaining) sticking out of the gearbox, I’m presuming the part of the shaft that failed and broke, is likely still in the hub.

I’d imagine Dan Benjamin has some already in stock or could make you a new shaft.

[Windcatcher530 Dan]

Exactly what Michael said !!!

[mtblah]

I agree also .w/Dan & Michael .

[Copter404]

I believe I PM’d Windybob for his contact info.

[Windcatcher530 Dan]

Matthew if you can it probably would be a good idea to get the mill on the ground and pull the hood off and check the inside for damage especially the gears.and snout of the mill.

[windybob]

I don't have a message from you....yet. Who's info do you want?

[CTXmiller]

WindyBob,

I think he was wanting Dan B’s phone # from you.