Vintage Windmill and Wind Generator Forum

Mike and Donna came to the Shattuck work week for several years. He took several mills home and reworked them. Mike was also on the board at Shattuck.
RIP Mike
Terry and Ruby

Thank you

Several months ago I picked up a 6 Ft. Diamond tail complete mill. The mill was close to a pond and on a wood tower. The anchors pulled out of the ground and the mill was laying in the pond. That is why the tail has a rust band on it. I restenciled the tail. The letters were very hard to read. IMG ...

Happy Birthday Gregg.

L. Louise Balsick

Louise Balsick age 93 of Calhan Colorado passed away peacefully on March 14,2025. She was born south of Calhan on January 9,1932, the youngest child of Andy and Anna (Trojanovich) Lemesany. Louise attended school starting at the one room schoolhouse north of Calhan and graduating ...

Robert William Cherry, affectionately known as "Wild Bill," passed away peacefully on November 23, 2024, in Loveland, Colorado, after bravely facing serious health challenges. Born on February 23, 1942, in Bristol, Colorado, Bill moved with his family to Loveland, Colorado in 1952, where he laid the ...

Most of the wood pitman arms were made out of hard Maple.
These are new ones that I made for a 8 1/2 foot Eclipse. The holes are not drilled for the wrist pins. A lot of the older windmills had the wood pitman arms

Peter
The tail bone is 1/4 X 1 1/2 X 60" with a cross brace at 38" from the horse end. The brace is 3/16 X 1" flat iron.
Looking from the horse to the wheel the straight sides of the hood are to the wheel and Left side.

Peter
No notches on my case.
When I first saw your pictures of the hood I thought it looked like a Dempster # 11 hood latch.
I will get some measurements on the tail bone tomorrow.

Peter
I looked in the Spring 1994 Windmillers Gazette there is a illustration of a #14 that looks like yours.
In the Winter 2010 Gazette there is a parts list that shows the cross bar like yours.
In the list is part # 1430 Guide rod spacer Obsolete sub 01430 and cut-off screw.
the next line down it ...